4.13.3.3. Digi CC-IMX6UL-SBC-PRO

This board is based on the i.MX6UL SoC.

The SBC Pro is shipped with:

  • 256MiB NAND flash

  • 256MiB DDR3 SDRAM

see https://www.digi.com/products/embedded-systems/single-board-computers/connectcore-for-i-mx6ul-sbc-pro for more information.

4.13.3.3.1. MAC addresses

The Digi modules save their MAC addresses not in the OCOTP nodes, but in the U-Boot environment. It is advised to boot the board using the shipped U-Boot Bootloader and to read out and save the MAC addresses for the board. The environment variables which contain the addresses are $ethaddr and $eth1addr. The MAC addresses can than be persisted to the barebox environment by using

nv dev.eth0.ethaddr=<eth0addr>
nv dev.eth1.ethaddr=<eth1addr>