1.22. Reset Reason

To handle a device in a secure and safe manner many applications are using a watchdog or other ways to reset a system to bring it back into life if it hangs or crashes somehow.

In these cases the hardware restarts and runs the bootloader again. Depending on the root cause of the hang or crash, the bootloader sometimes should not just re-start the main system again. Maybe it should do some kind of recovery instead. For example it should wait for another update (for the case the cause of a crash is a failed update) or should start into a fall back system instead.

In order to handle failing systems gracefully the bootloader needs the information why it runs. This is called the “reset reason”. It is provided by the global variable system.reset and can be used in scripts via $global.system.reset.

The following values can help to detect the reason why the bootloader runs:

  • unknown: the software wasn’t able to detect the reset cause or there isn’t support for this feature at all.
  • POR (Power On Reset): a cold start. The power of the system was switched on. This is a regular state and nothing to worry about.
  • RST (ReSeT): a warm start. The user has triggered a reset somehow. This is a regular state and nothing to worry about.
  • WDG (WatchDoG): also some kind of warm start, but triggered by a watchdog unit. It depends on the application if this reason signals a regular state and therefore nothing to worry about, or if this state was entered by a hanging or crashed system and must implicitly be handled.
  • WKE (WaKEup): a mixture of cold and warm start. The system is woken up from some state of suspend. This is a regular state and nothing to worry about.
  • JTAG: an external JTAG based debugger has triggered the reset.
  • THERM (THERMal): some SoCs are able to detect if they got reset in response to an overtemperature event. This can be a regular state and nothing to worry about (the reset has brought the system back into a safe state) or must implicitly be handled.
  • EXT (EXTernal): some SoCs have special device pins for external reset signals other than the RST one. Application specific how to handle this state.

It depends on your board/SoC and its features if the hardware is able to detect these reset reasons. Most of the time only POR and RST are supported but often WDG as well.